What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 18:12
What is lightning?
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Your Gmail Inbox Is Running Slow. Do These Things to Fix It - WIRED
the problem then depends on "how fast does the fuse operate?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Barnstars:
An AC voltage/ current source, and an ac inductive load.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Frequent Nightmares Linked to Faster Aging and Premature Death - Gizmodo
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
In schematic diagrams this is the symbol for a fuse:
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Answering the Nintendo Switch 2’s lingering accessibility questions - The Verge
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
(Dc diagram shown, AC is similar).
The Ocean Is Getting Darker, Threatening All That Lives Within - ScienceAlert
This is where the MOV conducts again, and dissipated the energy.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[image of Common-mode choke]
How AI chatbots keep you chatting - TechCrunch
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
First Sentence:
This device then solves the entire problem.
Mars isn’t Red? The Planet is Actually… - The Daily Galaxy
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There are three different concepts here that are getting confused.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The ‘inexcusable’ mistake Knicks made again and again in season-ending loss - New York Post
These are simplified answers to the original question, and does not change anything I wrote above.
One is “what exactly is in a ‘surge protector’ ? ”
Here is a simplified AC power diagram.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
A fuse is a non-resetable over current circuit protector.
Edit 2024–10.
The bolt then partially travels down the line to your home.
I post the exact comment here.
The other is “what does a “fuse” do?”
It also is a device that limits the change in current flow.
But it can get overloaded, and no longer works.
It seems Mohan does not understand the difference between a comment and an Answer.
Why do wives cheat with black guys?
He then describes Rainy Season and Lightning.
2024–10–10[John johnson John Johnson ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
These devices are installed between the “hot” and “neutral” and protective ground.
What is the reason for the high rate of unmarried individuals in America, particularly among males?
A circuit breaker is similar, but is resettable.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Because the load is inductive, the current lags the voltage.(by a bit).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
One
This one hit behind the barn.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–16 [ OO OLAOYE OYEBODE ]
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Now when you have a certain ac resistance, then a current flows in a loop.
eight
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
[old diagram got deleted by accident]
But… the neutral is now “floating” because of the 1 ohm resistance.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then describes the function of a fuse.
This is 'the assistant's answer'
The MOV will conduct when the voltage exceeds 50% of line voltage.
Upvotes:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
What does a fuse do?
At least they know the answer if they wanted it.
At one ohm, the resistor has a maximum of 1 watt power.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
but I think this circuit , shows a few more pieces.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
He then asserts :
The third is lightning and “how it gets conducted into a home.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
nine
There are two important concepts here.
a photo is worth a thousand words.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
so, what happens?
what exactly is a ‘surge’ protector?
For this case there are devices called Metal oxide varistors (MOV).
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".